2. EL 9
  3. nvme-stas
  4. stacd(8)

Scroll to navigation

STACD(8) STACD(8)

NAME

stacd - STorage Appliance Connector

SYNOPSIS

stacd [OPTIONS...]

DESCRIPTION

stacd is a system daemon that can be used to automatically connect to NVMe-oF I/O Controllers using the discovery log pages collected by stafd(8). It can also be manually configured with stacd.conf(5) to connect to I/O Controllers that otherwise cannot be found automatically.

OPTIONS

The following options are understood:

-h, --help

Print the help text and exit.

--version

Print the version string and exit.

-fFILE, --conf-file=FILE

Specify a different configuration file than stacd.conf(5) (default: /etc/stas/stacd.conf).

-s, --syslog

Send messages to syslog instead of stdout. Use this when running stacd as a daemon. (default: false).

--tron

Trace ON. (default: false)

--idl=FILE

Print D-Bus IDL to FILE and exit.

EXIT STATUS

On success, 0 is returned, a non-zero failure code otherwise.

DAEMONIZATION

stacd is managed by systemd. The following operations are supported:

Table 1. 

Command Description
$ systemctl start stacd Start daemon. 





  

    $ systemctl stop stacd 
    Stop daemon. The SIGTERM signal is used to tell the daemon to stop.
  











  

    $ systemctl restart stacd 
    Effectively a stop + start.
  











  

    $ systemctl reload stacd 
    Reload configuration. This is done in real time without restarting the
      daemon. The SIGHUP signal is used to tell the daemon to reload its
      configuration file. Note that configuration parameters that affect
      connections (e.g. kato), will not apply to existing connections. Only
      connections established after the configuration was changed will utilize
      the new configuration parameters.
  
















DESIGN


stacd
  

  use the GLib main loop. The GLib Python module provides several low-level
    building blocks that stacd requires. In addition, many Python modules
    "play nice" with GLib such as dasbus (D-Bus package) and pyudev
    (UDev package). GLib also provides additional components such as timers,
    signal handlers, and much more.






CONFIGURATION


stacd can automatically set up the I/O connections to
    discovered storage subsystems. However, stacd can also operate in a
    non-automatic mode based on manually entered configuration. In other words,
    storage subsystems can be entered in a configuration file named
    /etc/stas/stacd.conf. This configuration file also provides additional
    parameters, as log-level attributes used for debugging purposes.






D-BUS API


The interface to stacd is D-Bus. This allows other
    programs, such as stacctl, to communicate with stacd. The
    D-Bus address is org.nvmexpress.stac.






SEE ALSO


stacd.conf(5), stacd.service(8), stacctl(1),
    stafd(8), org.nvmexpress.stac(5).







  

    
    nvme-stas 2.2.1